View PDF
VELO ORANGE
Instructions for toe clip leathers kit
1.The leathers are long enough for XXL toe clips. If you have smaller toe clips you might need to trim the leathers to
length with a sharp pair of scissors or a razor knife.
2.Cut the thread into four sections about 18 inches (45 cm.) long. Thread the needle with one piece; you’ll be sewing
with a single strand of thread. Tie an overhand knot in one end of the thread.
3.Wrap the leather around one “leg” of the toe clip. Starting from the bottom of the toe clip, pass the needle through
the leather from back to front, so the knot will be under the leather. Then loop the thread over the leather and pass the
needle through both bottom holes as shown (photo 1). Pull tight.
4.Stitch to the top of the leather as shown (photo 2). Be sure to pull the thread firmly at each stitch.
5.Pass the thread over the leather and though both top holes. Do this twice as shown below (photo 3).
6.Stitch back down to the bottom on the opposite side and again loop the thread over the leather at the end (photo 4).
7.The needle should exit under the leather as shown below. Tie a knot and use the needle to “push” the knot under the
leather. Cut off the excess thread (photo 5).
8.Repeat the steps above on the other three toe clip “legs”.
If you need any additional help, please don’t hesitate to e-mail info@velo-orange.com
VELO ORANGE
Instructions for toe clip leathers kit
1.The leathers are long enough for XXL toe clips. If you have smaller toe clips you might need to trim the leathers to
length with a sharp pair of scissors or a razor knife.
2.Cut the thread into four sections about 18 inches (45 cm.) long. Thread the needle with one piece; you’ll be sewing
with a single strand of thread. Tie an overhand knot in one end of the thread.
3.Wrap the leather around one “leg” of the toe clip. Starting from the bottom of the toe clip, pass the needle through
the leather from back to front, so the knot will be under the leather. Then loop the thread over the leather and pass the
needle through both bottom holes as shown (photo 1). Pull tight.
4.Stitch to the top of the leather as shown (photo 2). Be sure to pull the thread firmly at each stitch.
5.Pass the thread over the leather and though both top holes. Do this twice as shown below (photo 3).
6.Stitch back down to the bottom on the opposite side and again loop the thread over the leather at the end (photo 4).
7.The needle should exit under the leather as shown below. Tie a knot and use the needle to “push” the knot under the
leather. Cut off the excess thread (photo 5).
8.Repeat the steps above on the other three toe clip “legs”.
If you need any additional help, please don’t hesitate to e-mail info@velo-orange.com
| Tech & Info |
